Trapezoidal Sheet 20-115 TP

• Profilhøjde: 18 mm
• Dækbredde: 1.030 mm
• Pladebredde: 1.080 mm
• Maks. pladelængde: 12.000 mm
• Godstykkelser: 0,40, 0,50, 0,60 og 0,75 mm
• Vægt pr. m²: 4,40-7,05 kg afhængigt af godstykkelse
• Vejledende lægteafstand: 1.000-1.600 mm afhængigt af godstykkelse
• Tolerancer: +/- 10 mm
• Montageretning: fra venstre mod højre
• Minimum taghældning: 5°
• Ved taghældning under 10° anbefales montage med dobbelt sideoverlæg
• Skruer pr. m²: 7 stk. ved tagmontage og 8 stk. ved vægmontage
• Kan udføres med bæreben for hurtigere montage, tæt sideoverlæg og korrekt montage af overlapskrue

Montagevejledning – Trapezplader

Spændtabeller – Trapezplade 20-115 TP

Produktkatalog

Farvekort

Premium farvekort

Trapezoidal Sheet 20-115 is a low, simple trapezoidal profile with a clean appearance, making it ideal for roofs, façades and ceilings. The other trapezoidal sheets differ in aspects such as profile height, cover width and load-bearing capacity. In general, higher profiles may be suitable for longer spans or greater strength requirements, while lower profiles are often chosen when a lighter and more discreet solution is desired.

The cover width is the width covered by the sheet when installed with the correct overlap. Trapezoidal Sheet 20-115 has a cover width of 1,030 mm, which is used when taking measurements and calculating material requirements.

The sheet thickness is selected based on the structure, span, load and application. The product catalogue specifies several sheet thicknesses for Trapezoidal Sheet 20-115, but the specific choice should always be based on the project requirements and installation conditions.

Roofs and façades are affected differently by wind, weather and loads. The product catalogue therefore specifies different screw requirements for roof and wall installation.